Hello!

I have just started to use the WinGauge control and I am a bit uncertain about some things.

I have focused on radial gauges so far, and I have used a preset that is available in the standard windows forms 13.2 edition of the controls. The

preset that I have used is the one that shows two different needles, one showing hot/cold and one showing full/empty. 

Questions:

1. Is there a way to get some sort of values printed out automatically that shows the value of the needle. ? I have seen that there are tick marks (major/minor) but I don't know if they can do more than just showing a line in different places. There are also some event "Render Label" but I don't understand how to se that.

2. Is there som way to invert the needle value scale? What I mean that depending on the left and right gauge, the needle value 15 in both these gauges gives a mirrored appearance. One needle is in the bottom, one in the top. But that is of course the radial way ;-)

Next to the needle value, there is a precision setting. How does that work.? (In the gauge designer).

Sorry for the bad writing, difficult to explain this. For me anyway ;-)

/Henrik