Hello,
when I run the Toolbox Utility for Version2011.1 on VS 2008 Professional SP1 it claims that it adds all components to the NetAdvantage tab. But in the last steps it will remove the tab from the toolbox. See output below.
Any suggestions besides choosing the toolbox items by hand?
Regards,
Torsten
Hi Torsten,
The only situation I can think of that ‘might’ potentially cause this issue, is where there are more than one version of NetAdvantage installed on the same machine. The Windows Form product, however has a feature which, (normally) automatically installs the tab and toolbox component, when the product is installed; is there any particular reason why you are using the Toolbox utility, as this may shed some light on why the utility is failing.
Sincerely,
Chris K
Developer Support Engineer
Infragistics, Inc.
www.infragistics.com/support
Hi Chris,
I have indeed an older version 2009.2 installed. In the past it was no problem to have two versions installed parallel. During installation of the product, the Toolbox tab was not installed. Therefore I tried to set it up manually with the Toolbox utility. Are there any logfiles written during installation to see why it is failing?