hi there,
i have updated a project from 7.2 to 10.2, i also save a lot of layouts for the ultradockmanager.now i cant read the oldlayout in the new version.
i had the same problem with the ultragrid, but i found a solution for convertig old layout´s. this solution does not work with the ultradockmanager.
has anyone an idea for migrating ultradockmanager layouts?
thanks
Michael,
I am sending you a sample application which loads a layout file to an ultraDockManager. I tried loading a layout file that was created in 2007 volume 2 and I had no trouble loading it to an ultraDockManager in an application that was created in 2010 volume 2.
Would you be able to send me your layout file and maybe a sample application with an ultraDockManager to which the layout file applies? Your application and layout file is most likely much more complex than my sample and may contain some feature that is not work properly after upgrading the application.
I would need to be able to examine it and test it myself.
Michael S.
Michael.
I have not heard back from you. If you do not require further assistance with this case may i close it? You can open it again if you need to within 30 days of its closure and you can always open a new case at any time.
Thank you for using Infragistics.
I've post the same issue to your support team three days ago without any response so far.Steps to reproduce:Launch WinToolBars/Docking sample from the WinFormsFeatureBrowserClick somewhere in the "ClassView" DockableControlPaneYou will see the control "flickering/shaking"To repeat turn between "Property" DockableControlPane and "ClassView"Frank
I apologize for the delayed response. I followed the steps that you have given but I am not seeing this "flickering/shaking" that you refer to. Are you seeing this in your own application as well? Do you have a sample that you could send me that reproduces this issue? I will need to be able to reproduce this behavior in order to attempt to resolve the issue.
I have not been able to reproduce this effect on my end. Would it be possible for you to send me a simple demo project that demonstrates this behavior?
Hi Michael,
No solution so far. No further response from Infragistics.
I've downgraded to 10.1 :((
Frank
hi frank,
did you find any solution for the flickering/shaking problem?
Michael Runda
I've made a capture. You can't see the mouse but you meight imagine.The "classview" shakes when I ckick in it. This effect only appears in the 10.2.