Select and Drag sets X and Y to negative numbers.

1470

Pete Sral posted over 14 years ago

I have a command button in a UltraGroupBox and I highlight (click on) it and try to move it and the position of the control is set to -143, -357

If I exit out of the IDE and come back in. I am able to move the controls that were added. As I add controls and move them... the new control's position are set to negative numbers.

Parents

17259

Offline Amiram Korach posted over 14 years ago

How do you check the button position?
Cancel
Reply

Cancel
1470

Offline Pete Sral posted over 14 years ago in reply to Amiram Korach

In Visual Studio 2008...when I have the designer up (form), I go to properties and find the control in the list and see the negative X, Y values.
Cancel
Reply

Cancel
17259

Offline Amiram Korach posted over 14 years ago in reply to Pete Sral

I thought you ment at run time. That happened to me once. I just changed the x and y properties in the properties window and it was fine. Make sure you have the latest hotfix.
Cancel
Reply

Cancel

Reply

1470

Offline Pete Sral posted over 14 years ago in reply to Amiram Korach

I'm on 9.2.20092.2058

I will post a bug report.
Cancel
Reply

Cancel

Children

1470

Offline Pete Sral posted over 14 years ago in reply to Pete Sral

Requested support for this issue: Case Number: CAS-41770-E76VTL
Cancel
Reply

Cancel